Standards Catalogue

Evidence conservation of failed axle bearings in service

This technical note sets out a methodical approach to collecting data at the point of failure and preserving the failed bearings for further analysis…

Level crossings - drivers' instructions

You will need this module if you carry out the duties of a driver.

Wrong-direction movements

You will need this module if you carry out the duties of a driver or signaller.

Master manual

The Rule Book manuals have been produced to provide end-users with access to the content of the Rule Book that is relevant to their roles, e.g.…

Possession Workers Manual

The Rule Book manuals have been produced to provide end-users with access to the content of the Rule Book that is relevant to their roles, e.g.…

Signaller and Signalling Technician Manual

The Rule Book manuals have been produced to provide end-users with access to the content of the Rule Book that is relevant to their roles, e.g.…

Train Driver Manual

The Rule Book manuals have been produced to provide end-users with access to the content of the Rule Book that is relevant to their roles, e.g.…

Track Workers Manual

The Rule Book manuals have been produced to provide end-users with access to the content of the Rule Book that is relevant to their roles, e.g.…

Train Operations Staff Manual

The Rule Book manuals have been produced to provide end-users with access to the content of the Rule Book that is relevant to their roles, e.g.…

ETCS stop marker

This document provides design details for sign AB08 - ETCS stop marker.

AWS Relays

Isolation and Earthing of Overhead Line Equipment

AWS Specification for Static Voltage Converter

Specification for Electro-Hydraulic Power Equipment for Point Operation

Relay Unit and Junction Box

Shunting Signals

Approach Locking

50Hz Single Phase AC Electrification, Immunisation of Signalling and Telecommunications Systems Against Electrical Interference.

AWS Electric Horn

AWS Reset Plunger

Section S - Protection of hand trolleys on running lines not under possession

Section T(iiiA) - Protection of engineering work in sidings

Section W - Bad weather affecting railway infrastructure

Section T(iii) - Protection of engineering work when the engineer takes possession of the line

Section V - Broken rails and bridge strikes

Section A - General responsibilities, safety and security

Section B(iii) - Your general duties when you are on or near the line

Section H(ii) - Working of trains - Out of course working and defective vehicles

Section K - Trains or vehicles detained on running lines and loops

Section P(i) - Working of single lines

Ground position light signal identification plate

This document provides design details for AC09 sign - Ground position light signal identification plate.

ETCS identification plate

This document provides design details for AC11 sign - ETCS identification plate.

GSM-R alias plate

This document provides design details for AC12 sign - GSM-R alias plate.

Permissible speed indicators (km/h)

This document provides design details for AD01k sign - Permissible speed indicators (km/h).

Permissible speed indicators (mph)

This document provides design details for AD01m sign - Permissible speed indicators (mph).

Permissible speed indicators (km/h) for limited clearance

This document provides design details for AD02k sign - Permissible speed indicators (km/h) for limited clearance.

Termination of AWS gap

This document provides design details for AA02 sign - Termination of AWS gap.

Commencement of AWS gap

This document provides design details for AA01 sign - Commencement of AWS gap.

Supplementary sign where crossing is used for animal traffic (PCR diagram 118)

No refuges sign

Crane Controller Competence for Twin Jib Cranes

This poster is provided by the M&EE Networking Group to remind industry that when using a twin jib crane under the control of one operator then there…

Use of warning horn

This poster is provided by the M&EE Networking Group to remind the industry about the use of the warning horn.

Code of Practice for Plant Any Line Open (ALO) Working

Code of Practice Protection of Non PTS Holders at OTM Stabling Points

This Code of Practice concerns all OTM stabling points and can be used when non PTS holders need to visit site. The document has been written to…

Code of Practice for Use and Loading of MEWPs

This Code of Practice details the use of MEWPs, particularly with processes for loads that should safely be permitted in the work platform of a MEWP.…

Injection Injury

This poster details the actions to be taken following a hydraulic injection injury.

Code of Practice Planning for the Use of Mobile Operated Plant

Points run throughs

Code of Practice for Action to be Taken in the Event of an Accident or Incident Involving OTP

This Code of Practice details the actions to be taken, and by whom, following an accident or incident involving OTP.  It deals with the engineering…

Code of Practice for Management of Points within Engineering Work Sites

This Code of Practice is to provide guidance on the arrangements for the Management of Points within Engineering Worksites for all rail borne vehicles…